In all cases the surface shall be clean and free from anything that would inhibit the bonding capacity of the Flexcrete Waterproofing System. Surface must be structurally sound and free of any bond breaking materials. All cracks, spalls, voids shall be repaired prior to application.
Place Flexcrete Polymer in empty five gallon container. Place the appropriate amount of liquid based on application type. Using a dual bladed rotary mixer on a high speed drill start mixing the fluid and slowly add the Flexcrete Compound, mixing continuously until a creamy, smooth, lump free pancake batter consistency is achieved.
Once thoroughly mixed, stop mixing and allow the material to dwell or fatten for a period of five minutes. After five minutes, remix and add additional fluid if necessary to the desired consistency. Apply to a dampened SSD (Saturated Surface Dry) substrate by roller, brush, trowel or spray. It is preferred to apply the material and work sufficiently into the surface filling all pits holes and voids. Allow to dry overnight.
Apply the second coat in the same manner as described above only perpendicular to the first application. Allow to cure overnight before further applications and seven days prior to water testing on swimming pools.
All materials should be kept out of the sun and heat. This excessive heat will accelerate the hydration or setting process. To extend the pot life of the material fill a garbage can or vessel larger than the five gallon bucket diameter with ice and water. Place the mixing fluid in the container prior to using and keep in container while work progresses. This will extend pot life 20-30 minutes. At 70 degrees F. The pot life is approximately 30 minutes.